41
Bedroom Slideout
Access to move slide when no power is available is under the bed.
1. Remove any and all cargo from under the bed.
2. Pull up plywood panel covering mechanism.
3.
Find shaft on front side of gear box. Use 3/4” socket and ratchet
to turn shaft in direction you wish to move slide.
Schwintec Wall Slide
This system is composed of four tracks placed on the outer sidewall of
the slide, two at the bottom and two near roof line. On each side, an
extrusion is attached to the sidewall with a motor inside at the top of
extrusion, accessible only from inside. A gear mounted to the motor will
run on the upper track to move slide in or out. Wire harness is alongside
of extrusion.
Power is supplied by 12-volt, converter and/or auxiliary battery through a
module board, located under the slide or near the slide in a cabinet.
Operation error codes are listed and found in the manual supplied by the
manufacturer of equipment for circuit board and other components.
It is very important to keep tracks clean from dirt and debris.
Don’t forget, each side has its own motor. Should slide move at an angle,
one motor may be disconnected or failed to move.
Manual Override
A. MANUAL OVERRIDE, ELECTRIC
1. Locate the circuit board.
2.
Press the “mode button six times quickly, press a 7th time
and hold for approximately 5 seconds. The red and green
LED lights will begin to flash, confirming the override mode.
3. Release mode button.
4. Back inside coach, use the normal control switch to retract
the slideout.
B. MANUALLY PUSH SLIDEOUT IN OR OUT
1. Unplug both motors from circuit board. This releases the
motor brake.
2. Push or pull slide room in as desired. Larger rooms may
require several people to move slide. Keep both sides
even.
3. When slideout is completely in, plug both motors back into
the circuit board to apply brake for road travel.
4. Slideout must be travel locked during travel.
