Multi-Image Splicing Processor
7
Clipped View
Select by finger key
Image 1
Image 3
Image 2
×1
×10
×100
Save Setting
Horizontal
Horizontal
Vertical
Vertical
Size:
Mode 8
Turn knob to select image
Click
“
OK
”
to adjust
Current
mode
does not exist!
Save Mode 1
Device Mode
Image Layout
Mode 1
Mode 2
Mode 3
Mode 4
Mode 5
Mode 6
Mode 7
Note: This step should be skipped if full display of signal source is required on
large screen; while if certain signal source of multi-image is needed to be extracted,
only setting of signal source image is required; if horizontal size or vertical size is 0, it
means no local extraction is required in this direction.
Step 6:
Click “MENU” and return to main menu interface; select “Save setting”
to enter into Data storage interface; select any mode and click “OK” to save data.
Note: Mode 1 is default startup data of device boot; it’s suggested that the most
common mode or that required by device boot should be saved to Mode 1.
At this point, basic device debugging is completed. If there is other requirement,
repeat the operation and save it as other mode.
After device debugging, just call saved data according to different condition
requirements in later stage.
Data call is divided into forms: