Canopy
Paint.
Decal
(Cockpit panel)
For the correct location of decals,
please refer to the next clause.
2 x 8 m m
Receiver / Battery
Foam Pad
Move the location of the receiver and battery pack
as needed to obtain the specified CG.
Carefully install the receiver and battery pack to
ensure that they will not move during flight.
Control Surface Movement
CG
90~ 100mm
AILERON
10mm
10mm
RUDDER
30mm
30mm
ELEVATOR
15mm
15mm
•This model aircraft is designed for Intermediate to Experienced fliers. Beginners should seek advice for pre-flight adjustments and assembly
from more experienced fliers. Be aware that flying a badly assembled or badly adjusted aircraft is very dangerous!
•At the start, first-time fliers should always be assisted by an experienced flier and NEVER fly alone!
•This model aircraft is designed to be powered by either a 2 stroke .40 ~ .46 size engine or a 4 stroke .48 ~ .53 size engine. Installing a more
powerful engine than specified or flying this model dangerously could lead to serious injury and/or damage to property.
Cut off shaded portion.
Drill holes with the specified
diameter (here: 2mm).
Pay close attention here!
Assemble left and right sides
the same way.
Must be purchased separately!
Do not overlook this symbol!
Adjust the travel of each control surface to the
values in the diagrams.
These values fit general flight capabilities.
Readjust according to your requirements
and flight experience.
Never fly before checking the CG's required position.
Secure foam padding with
rubber bands or tape as required.
2 x 8mm
TP Screw
4
14
