12
3.
Make sure that the paper tray is lowered and stopped. Then, while
watching the side plates inside the feeder, rotate the paper adjuster knob
on top of the feeder clockwise. Stop rotating the knob when the side
plates have been set to their widest settings (outmost positions). See
figure below.
4.
Place several sheets of the paper you are going to use with the feeder on
the center of the paper tray.
5.
Adjust the side plates by rotating the adjuster knob on top of the feeder
counterclockwise so that the left and right side edges of the paper are
flush with the left and right side plates.
Then, rotate the adjuster knob half a turn clockwise. This allows an
approximately 1 mm gap between each side of the paper stack and the
side plate, which is needed to ensure the proper paper feeding. See
figure below.
Note
Make sure that the paper edges are evenly aligned on the
center of the tray and the front edge of the stack fully abuts
on the feeders inside panel.
Cover
Inside Panel
Side Plates
Tray
Paper
Adjuster Knob
All manuals and user guides at all-guides.com
