Kyocera 4850w, Operation Manual

Page: 59 / 108

CHAPTER 6 CONVENIENT FUNCTIONS
6-11
1
4
5
2
3
(Inch)
(Metric)
(Metric)
(Inch)
6. Interrupt Copy
If the Interrupt key is pressed while a copy job is being run, the
current copy will be interrupted and another copy job can be run.
NOTE
• If the Interrupt key is pressed after an interrupt copy is complete, the
interrupted job can be resumed under the original copy conditions.
• Interrupt copy can function except when an original is being
scanned.
• When originals are being scanned continuously in the sort mode,
interrupt copy cannot function.
• Once a document scan exceeding 60 pages has been initiated, the
interrupt copy will not be available until the preceding copy operation
completes.
• When a scan/copy operation exceeding 60 pages is complete and
an interrupt copy is initiated, the memory of scanned originals of the
previous copy job will be cleared and so the repeat copy of the
previous copy job is not available.
Press the Interrupt key while a copy is being output.
The Interrupt indicator will light up. Copying will be
interrupted after a copy that is being output is ejected.
Set copy conditions as needed and set an original for
interrupt on the original table.
Interrupt copy will start.
After copying is complete, to make another interrupt copy,
press the Reset key and repeat step 2.
When the interrupt copy is complete, press the Interrupt key.
The interrupt indicator will go out and the machine will
restore the copy settings for interrupted copy.
To resume interrupted copy, press the Start key.