42
MAINTEN ANCE
Transmission fluid change
1. Place the scooter on its main stand.
3. After the fluid has drained out, reinstall the drain bolt with a
new sealing washer and tighten it to the specified torque.
2. Place a suitable container (drain pan) under the transmis-
sion case on its left side. Remove the drain bolt
1
to
drain the fluid.
1
1
1
1
1
2
2
2
2
2
3
3
3
3
3
Transmission fluid type:
SAE 90
Transmission fluid capacity: 0.12 qt (0.11 L)
NOTE: The fill amount specified is the amount to use after
completely draining the used transmission fluid.
6. Install the transmission fluid filler bolt with a new sealing washer
and tighten it to the specified torque.
Transmission fluid filler bolt torque: 15 lb-ft (20 N-m)
Transmission fluid drain bolt torque: 15 lb-ft (20 N-m)
4. Remove the transmission fluid filler bolt
2
.
5. Add the exact specified fluid through the fluid filler hole
3
.
Using the wrong transmission fluid type or viscosity
may cause premature transmission component wear.
Do not exceed the specified amount when adding trans-
mission fluid. If too much fluid is added to the trans-
mission case it could be forced into the air cleaner as-
sembly during operation, causing air filter contamina-
tion and poor engine performance.
2
2
2
2
2