![background image](http://html1.mh-extra.com/html/kyland/sicom3432g-series/sicom3432g-series_hardware-installation-manual_2014807012.webp)
Mounting
7
You can select the screw holes for front or rear panel mounting to install the mounting
brackets. If there are screws inserted in the screw holes, remove the screws and keep them
for future use.
As shown in the following figure, use four screws to secure two mounting brackets to the
switch respectively.
Screw holes for rear
panel mounting
Screw holes for front
panel mounting
Screw holes for front
panel mounting
Screw holes for rear
panel mounting
Figure 4 Installing Mounting Brackets
Mounting
Step 1: Select the mounting position for the switch and guarantee adequate space and heat
dissipation (house dimensions: 440mm
×
44mm
×
245mm).
Step 2: Move the switch in direction 1 until the screw holes for securing the mounting
brackets to rack posts are in alignment with the corresponding holes in the rack
posts. Then use four screws and supporting captive nuts to secure the mounting
brackets to the rack posts.
Dismounting
Step 1: Remove the four screws and supporting captive nuts securing the mounting brackets
to the rack posts.
Step 2: Remove the switch from the rack posts. Then unscrew the mounting brackets to
complete dismounting.
Caution:
Cut off the power and disconnect all cables before mounting, dismounting or moving the
equipment.