Advanced Configuration
36
Priority
Range: 0~7
Default: 0
Function: Set the default priority of the port. When adding an 802.1Q tag to an untagged
packet, the value of the PRI field is the priority.
PVLAN
Options: Enable/Disable
Default: Disable
Function: To add a Tag port to a VLAN, you need to enable or disable PVLAN. For details
about PVLAN, see the next chapter.
Caution:
An Untag port can be added to only one VLAN. The VLAN ID is the PVID of the port. The default
value is 1. A Tag port can be added to multiple VLANs.
3. View the VLAN list, as shown in the following figure.
Figure 34 Viewing VLAN List
PVLAN List
Options: select/deselect
Function: Enable or disable the PVLAN function. For details, see the next chapter.
4. View the PVIDs of ports.
Click <Untagged Port VLAN List> in Figure 34. The following page is displayed.
Summary of Contents for SICOM3024P
Page 13: ...Product Introduction 6 management software and SNMP network monitoring...
Page 25: ...Device Status 18 Figure 15 System Operating Information SICOM3024...
Page 73: ...Advanced Configuration 66 Figure 67 Setting ACL Entry Parameters Group 2...
Page 145: ...Advanced Configuration 138 Figure 137 Dynamic Unicast FDB Table...
