EN
PL
16
RU
DE
OPERATING INSTRUCTIONS
APPLICATOR OPERATION
Screw the pump off the head - to do this, lock the piston rod (fig. 5b/pos. 1) in the cylinder brackets (fig. 5b/
pos. 2). Unscrew the pump counterclockwise, holding the piston rod (fig. 5b/pos. 1).
Insert the strainer (fig. 6/pos. 2) to the head cup (fig. 6/pos. 1) and pour in the previously prepared spray liquid
in accordance with manufacturer guidelines.
In order to secure the spraying nozzle against contamination when filling the tank with the spray liquid, it is
recommended to rest the lance on the head (nozzle facing upwards).
Remove the strainer (fig. 6/pos. 1) from the head cup (fig. 6/pos. 2). Screw the pump (fig. 1/pos. 5) into
the head (fig. 1/pos. 4). To do this, lock the piston rod (fig. 5b/pos. 1) in the cylinder brackets (fig. 5b/pos.
2). Remember that the connection must be airtight. The locked piston rod may be used as a transport handle.
Clean any dirt off the strainer.
Move the applicator to the work site. Use the piston rod (fig. 4c/pos. 1) to pump the applicator (around 20 full
motions) until the safety valve operates (fig. 4a/pos. 1). As soon as the safety valve opens (fig. 4b), maximum
tank pressure has been reached.
Point the lance tip (fig. 7) at the location to be sprayed.
Next turn the ball valve lever for spraying (fig. 8b). Spraying should be performed according to main wind
direction.
1
Fig.7
Fig.8a
Fig.8b
The ball valve closed
The ball valve open
1
1
2
2
