EN
Instruction Manual
HydroPneumatic tool for rivet nuts from M3 to M12
with oil pressure adjustment
FASTSETM12
www.kvt-fastening.ch
137
6 -
OPERATION
6.1 -
OPERATORS
The tool is designed to be used by one operator only.
Tool operators must satisfy the requirements stated hereafter (or they must be informed and trained accordingly). They
must be aware of the manual herein and of all information relevant to safety:
They must have some general and technical education, to a sufficient level to be able to understand the manual and to
interpret the drawings and the diagrams correctly.
They must be acquainted with the main hygienic rules, and with the industrial-safety and technological instructions.
They must have an overall knowledge of the line and of the factory in which the tool is installed.
They must know what to do in case of emergency, where to find the individual protection means and how to use them
correctly.
Together with the above-mentioned requirements, the service technicians must also have an appropriate technical training.
P 1
MOTOR
SCREWING
When the rotating pin (
6
Code
4151500
) is broken and you replace it, it may happen that the motor rotates
continuously, which means that the shaft (
13
Code
3761300
) is too long; in this case it will have to be
shortened by a few tenths to obtain the closure of the ball (
14
Code
3096900
). When the air is on, the shaft
shall have no end float.
Unlike the situation above, the shaft is too short and it has to be replaced with a new one, fitting it without
end float, with the air on, in order to obtain the closure of the ball (
14
Code
3096900
).