2.6
Completing the Installation
Process
If the system has initialized properly and is functioning, replace
the radome on the baseplate (labels on the sides), securing it with
the eight pan head screws and flat washers removed at the start
of the installation process.
As noted previously, while some DIRECTV IRDs offer on-screen
messages, it is recommended that a PC be available for all
installations of both DIRECTV and EchoStar. This will permit the
installer to record the TracVision SA startup sequence to verify
that the unit is functioning within specified parameters. Baseline
startup parameters (with optimal ranges) have been provided in
Appendix E
.
2.7
Configuring TracVision SA for
Remote Satellite Dish Operation
In some campground locations, dense foliage will block the
satellite signal. In these situations, a remote portable antenna
may be the only solution to satellite signal reception.
The wiring option for the remote dish is very simple and
should be installed when the TracVision is installed. A high-
quality “A/B switch” should be used to change from TracVision
to remote antenna operation. The recommended wiring
arrangement for remote dish operation is illustrated in
Figure 2-20.
2-14
A Guide to TracVision SA
If a need does arise to paint the
radome, ONLY use non-metallic
automotive paint to avoid
degrading the RF signal strength
and the reception quality.
IRD
A/B Switch
A
B
A
B
Common
TV Out
SAT in
TracVision SA
Remote Dish
Figure 2-20
Remote Dish Wiring
Configuration
