4
b.
Connect the appropriate data cable (B) for
your installation type (see Figure 3 on page 3)
from the switchplate to the “Control Output”
connector on the Tri-Sat AutoSwitch.
NOTE:
Switchplate wiring varies according to
installation type. The kit contains multiple data cables
to accommodate several TracVision products and
configurations. Refer to the Contents List for data
cable photos and part numbers.
If
you are installing an Tri-Sat AutoSwitch
Kit to upgrade a TracVision system that is
already installed on a vehicle
, be sure to use
the RJ22-to-DB9 data cable (KVH Part #32-
0916-25) supplied in the kit. You will connect
the DB9 end of the cable to the front of the
TracVision switchplate (see Figure 3 on
page 3).
If you are installing an Tri-Sat AutoSwitch
Kit as part of a new TracVision system
installation
, be sure to use the RJ22-to-RJ22
data cable (KVH Part #32-0724-25) supplied
in the kit. You will connect to the RJ22
connector on the back of the TracVision
switchplate (see Figure 3 on page 3).
c.
Connect one end of a coaxial cable (C) to the
“To DIRECTV HD Receiver Coax” connector
on the Tri-Sat AutoSwitch. Connect the other
end to the “Satellite In” connector on the
DIRECTV H21-200 or H20-600 receiver.
d.
Connect one end of the USB cable (D) to the
“To DIRECTV HD Receiver USB” connector
on the Tri-Sat AutoSwitch. Connect the other
end of the cable to the “USB” connector on
the DIRECTV H21-200 or H20-600 receiver.
