9. At each bracket, position a retaining block
underneath the crossbar and insert two swivel
nuts,
1
⁄
4
" flat washers, and lock nuts into the captive
holes from below. While holding this hardware in
place, screw the bracket’s screws into the retaining
block’s swivel nuts, washers, and lock nuts using a
1
⁄
4
" driver and the supplied T27 TORX bit
or Snake
Eyes bit
, as required. After securing all four
brackets to the crossbar, verify that all cushions are
pressed firmly against the crossbar, providing a
solid grip. Also check to make sure that all eight
screws have engaged the nylon inserts in the lock
nuts.
3
TracVision A5 Installation Guide – ADDENDUM
54-0208-01 Addendum to Rev. C
Securing the Tamper-proof Screws
Tamper-proof
Screws
Retaining Block
Retaining Block
Swivel Nut
Flat Washer
Lock Nut
Summary of Contents for TracVision A5
Page 1: ......
