13
Mount the VSAT-Hub
TracPhone V30 Installation Guide
Mount the VSAT-Hub
Follow these steps to install the VSAT-Hub inside the
vessel.
1.
Tape the mounting template in the location selected
for the VSAT-Hub. Punch holes at each of the two
keyhole locations and at the mounting tab location.
Figure 17: VSAT-Hub Mounting Template
2.
Remove the template.
3.
Drill a 1/8" (3 mm) hole at the three hole locations you
marked in step
1
.
4.
Install a #8 Phillips thread-forming screw partway into
one of the keyhole holes leaving a small gap for
hooking the VSAT-Hub onto it. Use the thickness
(2.5 mm) of the M10 washer (
supplied in kit
) as a gauge
for the size gap to leave.
5.
Repeat step
4
for the other keyhole.
6.
Peel off the backing on the adhesive-backed washer
(
supplied in kit
) and place it over the mounting tab
hole.
7.
Align the wide part of the VSAT-Hub’s keyholes, as
shown in Figure 17, over the screws, then slide
downwards to secure the screws into the narrow part
of the keyholes.
8.
Press the rear mounting tab of the VSAT-Hub onto the
adhesive washer and install the third #8 Phillips
thread-forming screw in the mounting tab hole.
