5
Follow the steps below to bypass the UHD7
antenna’s DSWM by connecting its RF cables to
the bypass bracket.
a.
Locate the DSWM inside the UHD7 antenna
and identify the RF cables connected to it.
Note that RF4 and RF5 are already connected
to the DSWM bypass bracket (see
).
NOTE:
To avoid damage, avoid excessive twisting or
sharp bends in the cables while tightening.
b.
Using a 7/16" open-end wrench, carefully
disconnect each of the cables shown in
(RF2, RF1, 13V, and 18V), and
connect them, one at a time, to the
corresponding connectors on the DSWM
bypass bracket.
c.
Tighten the connectors with a 7/16" torque
wrench set to 15 in.-lbs.
Figure 4: RF Cables Connected to the Antenna’s DSWM
13V
18V
13V/
KHz
18V/
KHz
SWM2
SWM1
RF2
RF3
RF5
RF4
Bypass
Bracket
13V
18V
RF1
RF2
Figure 5: Connecting the Antenna Cables to the Bypass Bracket
13V
18V
RF1
RF2
13V
18V
13V/
KHz
18V/
KHz
Bypass the Internal DSWM
3
