Adjustments
44
Passive knife skids
Introduction
Use this configuration if:
•
You want a coarser level and surface finish in order to avoid any
risk of surface breakdown.
•
You are working in the autumn and you want to sow in the spring.
•
You are not planning to sow for a long time.
Adjustment procedure
on Actiring and Actipack
Raise the knife skids fully to put them in the
OFF
position (folded
away).
Loosen the locknut.
Loosen the countersunk screw (
A
) with the small wrench (
B
) so
that it protrudes by about 1 cm from its conical housing.
Loosen the locknut on the other side.
Engage the long wrench (
C
) on the welded nut located on the lower
part, so that the rear rail is supported.
While holding the wrench (
C
) in position, loosen the countersunk
screw (
A
) with the small wrench (
B
) so that it protrudes by about 1
cm from its conical housing.
Swing the rail to the required position (
1
,
2
,
3
or
OFF
).
Still holding the wrench (
B
) in position, fully tighten the countersunk
head screw (
A
).
Tighten the locknut.
Go to the other side to fully tighten the other countersunk head
screw (
A
). If necessary, use wrench (
C
) again to adjust the
alignment of the screw to the desired position.
Tighten the second locknut.
Scrapers on Actipack
If using scrapers on the roller:
Set the scrapers to the
OFF
position.
The scraper must not touch the central tube, respect a clearance of
5 mm (
3/16”
) to 10 mm (
6/16”
) from the tube.
A
B
C
