www.kvarta.net
9
/
32
9
DVB Monitor M1 User Manual 2.21
3.4
System Reset
How to reset the DVB Monitor to its default IP address (
192.168.2.3
) and default settings:
•
Remove SD card from the DVB Monitor
•
Use a card reader to plug the card in a computer or laptop, tablet, etc.
•
Delete the
config.ini
and
config2.ini
files, located in the SD card’s main directory
•
Place the card back into the DVB Monitor, switch it on and wait for about 60 seconds
•
The device has now been hard reset to its default IP
4.
CONFIGURATION AND OPERATION
4.1.
STREAMING mode - single carrier measurements and streaming
4.1.1.
RF Configuration
•
Open the embedded web page and click
CONFIG -> Config
•
Streaming mode should be ON as it is in the picture below
•
Select the modulation type Analog/DVB-C/DVB-S/DVB-S2/DVB-T2/DVB-T
1
•
Type the center frequency of the monitored carrier
•
Click Save & Tune
•
Connect the RF Antenna or CATV source to IN A or IN B
•
Select the appropriate Input (A or B) used for the type of modulation Analog/DVB-C/T/S etc.
•
Configure other relative settings like Bandwidth, Symbol Rate, Constellation and Spectrum in
the
CONFIG -> General
tab
•
Click the Save button below the settings to store the configuration
1
Depends on the DVB Monitor model
