42
|
51
Logolas series - v120221
Kvant Lasers s.r.o.
EN
Always loosen one of the screws in the pair first, before tightening the 2nd one down.
!
All alignment screws A,B,C and D must be fastened at the end of each beam alignment procedure. Even
if only one of them is loose, there will be not enough internal pressure on the pivoting bolt (E), which may
result into misalignment of respective colour.
!
9. Create a full size magenta circle (static tunnel effect) and check whether the blue circle overlays the red circle all the
way around the shape. If not, follow the diagram above to adjust the beam path accordingly (step 2 on the diagram
above).
10. Create a full size yellow circle (static tunnel effect) and check whether the green circle overlays the red circle all the
way around the shape. If not, follow the diagram above to adjust the beam path accordingly (step 3 on the diagram
above).
11. Finally create a full size white circle (static tunnel effect). If the alignment procedure was done successfully you can
see all the colours nicely overlaying each other, resulting in even, bright and sharp circle like the one on the picture
below.
