Initial Cut on New Chip Out Block
3-15
KVAL Operation/Service Manual
Initial Cut on New Chip Out Block
Making a new chip out block requires two people. one person will operate the 960-3 as normal
from the front side.
Insert a test jamb
When the router moves to the forward position into the jamb, the seconds person quickly butts
new Chip Out Block against the jamb and tightens thumb screw.
The router will cut into the Chip Out Block when it returns to the starting position.
Note:
Cycle Time Is Approximately 7 Seconds
Insert Chip Out Block
from the back of the 960-3
to Butt up against test
jamb.
Tighten Chip Out Block
with Thumb Screws
KVAL P/N:CHIPOUT35
Keep Hands away from the front cutting
area of the machine.
Summary of Contents for 960-3
