Model
wAv 212
Stereo guitar amp with digital effects and selectable preamps
Input Impedance
Output Power
60W per channel
8 Ohms @ 5% THD
Hum & Noise
-50dB
Residual Noise, all level controls 0% (minimum)
30 dB
Lead Channel, Clean Preamp output
40dB
Lead Channel, Classic Preamp output
60dB
Lead Channel, Crunch Preamp output
60dB
Lead Channel, Wave Preamp output
6dB
Lead Channel added gain for all settings with Boost on
35dB
Rhythm Channel, Shift Out
40dB
Rhythm Channel, Shift In
35dB
Power amp gain
USA/Canada
120VAC/60Hz, 200W nominal
Europe
230VAC/50Hz, 200W nominal
UK
230VAC/50Hz, 200W nominal
Australia
240VAC/50Hz, 200W nominal
Japan
100VAC/50-60Hz, 300W nominal
mm/kg
540 (Height) x 700 (Width) x 280 (Depth), 25.4kg
Inches/Pounds
21.25 (Height) x 27.5 (Width) x 11 (Depth), 56 lbs
Dimensions
Power Requirements
Digital Effects
Footswitch
System Gain
All measurements taken with 1 KHz
input signal, Tone controls flat, Gain
and Volume Maximum Boost off
unless noted. Measured at preamp
output jacks on rear unless noted.
There are 45 selectable effects separated into 3 groups of 15. One effect from each group
active at the same time. Up to 3 groups active at the same time.
There are 12 user presets. Each preset stores all setting for the 3 groups. There are 4
Favorites banks. Each favorites bank contains 3 user presets. Presets in the banks are
selected by tracking the channel select and Lead Boost button status.
Total Harmonic Distortion
Frequency Response
20HZ-20kHz
Actual response is tailored to speakers for accurate acoustical
response using a guitar as input.
Less than 0.4%
Because of the intentional distortion created by using some of the
preamps and effects, this Distortion is measured from the power
amp input signal to the output to speakers.
200K Ohm
18 Bit 44.1Khz sampling rate Stereo Processor with onboard firmware flash memory
64K User Memory
Use any standard CAT 5 cable wired to the 568A or 568B standard
Use only with Model: KAC-FSWAV (supplied with amplifier)
13
Specifications
