1. SYNC IN:
This balanced XLR Jack accepts the SYNC output from another PA unit using a standard mic cable.
Channels from both units are summed together. Use the channel volume controls to get the mix of the channels (If a channel is not
used turn the volume all the way down). MASTER volume controls the loudness of the mix. It does not affect volume of a linked PA
product.
Note: The shield connection (pin 1) on this jack is connected to chassis ground. It is not lifted.
2. SYNC OUT:
This balanced XLR Jack accepts the SYNC input from another PA unit using a standard mic cable.
Channels from both units are summed together. Use the channel volume controls to get the mix of the channels (If a channel is not
used turn the volume all the way down). MASTER volume controls the loudness of the mix through the primary unit, not the linked unit.
This jack may also be used to connect the PA product to the balanc ed line input of a power amp.
Note: The shield connection (pin 1) on this jack does not connect to chassis ground, it is lifted.
3. Bluetooth LED (PA40BATBT ONLY):
Indicates that a Bluetooth equipped device has successfully paired with the PA40BATBT.
4. CHARGING LED:
Indicates the battery is charging. It is recommended to charge for 12 hours after use. Battery charges even if the
unit is ON under normal volume conditions. When played loud, the battery will stop charging to allow higher power demand. To resume
charging, uplug AC power cord, then reconnect after 10 seconds.
Note: LED indicates “rapid charge” stage and will turn off when unit enters “float charge” stage.
5. BATTERY LEVEL INDICATOR:
During use, the BATTERY LEVEL indicator LED’s show the remaining battery power. When the red
light on the left is on, turn off the unit and recharge to avoid excessive battery drain.
6. AC Power Cord Receptacle & Fuse Holder:
Insert the AC cord firmly into the AC receptacle. Power circuit is on whenever AC cable is connected to unit and plugged into wall.
Be sure to use the cable provided with your PA40BATBT. The power cord can be removed for storage or replacement if damaged.
Note: Replace the AC cord if its protective jacket is damaged or ground pin is damaged or removed.
7. Power:
This switch activates power to the Battery Powered PA.
Note:
Power is supplied to the unit for charging even if Power switch is off.
2
1
4
6
5
3
7
PA40BATBT:
BLUETOOTH PAIRING INSTRUCTIONS
To connect your Bluetooth device to the
Kustom Bluetooth receiver for the first
time, navigate to the Bluetooth settings menu
on you Bluetooth enabled device. Ensure that
Bluetooth is enabled and your Kustom
product is powered on. Perform a scan for
available devices. Select and pair to the
Kustom product in the list of available
devices. Enter 0000 for the passcode if
prompted. Once paired, a connection can be
established. Depending on the device, future
connections may be established automatically
when a previously paired Bluetooth device is in
range of the Kustom Bluetooth receiver.
The Bluetooth receiver in Kustom Bluetooth
products is an A2DP device and will work with
other A2DP compatible Bluetooth devices
including most smart phones. Additional
hardware and/or driver software may be
required for computers with integrated Bluetooth
adaptors due to a lack of support for A2DP
devices by some operating systems.
A2DP protocol only allows for one to one device
connections. Therefore, only one Bluetooth
device can be connected to a Kustom
Bluetooth product at one time. Similarly, a
Bluetooth device can only be connected to one
Kustom Bluetooth product at one time.
Plugging a 1/8” connector into the AUX jack
disables the Kustom Bluetooth receiver.
Summary of Contents for PA40BATBT
Page 2: ......
