4
1.) Guitar Input Jack -
2.) VOLUME -
3.) MASTER -
4.) CHANNEL -
7.) MIDDLE -
10.)LEVEL -
11.) Power Indicator
This is a 1/4” 2-conductor input jack for plugging in your instrument.
It is intended for guitars but will accept other instruments as well.
Adjust this control clockwise to increase the amount of distortion. Use in the
lower ranges (counter clockwise) to produce less distorted tones. As you increase the
volume (clockwise), the amount of distortion can range from “Classic Rock” to heavy,
modern rock.
This is a volume control for the Lead channel only.
This switch selects between the Lead and Rhythm channels.
This passive midrange control centers both channels at 800Hz.Turning it fully
clockwise, the signal is unaltered. Turning it counterclockwise, the low end will be rolled off
-12db.
This control increases the effect signal and mixes it with the guitar signal.
Turn the control clockwise to add the desired level of effects .
- When lit, the amplifier is turned on and ready for use.
5.) VOLUME (Rhythm) -
6.) BASS -
8.) TREBLE -
9.) Delay/Reverb-
This is a volume control for the Rhythm channel only.
This is the bass control for both channels. This passive control adjusts
frequencies at 800Hz and below. Turning it fully clockwise, the signal is unaltered. Turning
it counterclockwise, the low end will be rolled off -12db.
This is the high frequency control for both channels. This passive control
adjusts frequencies at 3K Hz and above. Turning it fully clockwise, the signal is unaltered.
Turning it counterclockwise, the low end will be rolled off -12db.
This switch will toggle the effects selection between Delay and Reverb.
66 DART
Front Panel
™
