background image

INSTALLATION INSTRUCTIONS

1. Locate a convenient place on the vehicle to mount the AUTO EJECT. A minimum

clearance of 3" behind the mounting panel is required.

2. Place the template in position and center punch in 5 places.

3. Drill 4 mounting holes, 3/16" diameter and one, 1 3/4" clearance hole for the

AUTO EJECT.

4. On the 2 conductor cable the black wire is Connected to the vehicle's ground and the

white wire to the vehicle's starter. USE #16 GAUGE WIRE OR HEAVIER.

5. On the 3 conductor cable connect the Green, Black and White power wires to the

accessories on the vehicle.

6. Test installation by installing mating connector into the AUTO EJECT. Energizing the

starter should energize the solenoid and eject the connector.

7. Keep connector and contacts of the AUTO EJECT clean. Clean contacts with WD-40

solvent as required.  Make certain that WD-40 is dry before returning to service
NOTE THAT WD-40 SOLVENT IS FLAMMABLE AND MAY BE IGNITED BY A SPARK
 Lubricate contacts monthly with "vaseline" to insure free operation.

Note: USE ONLY CORD CONNECTOR (PLUG) SUPPLIED WITH THE AUTO EJECT

All connectors are not identical, using a substitute may result in unreliable
operations or failure of the AUTO EJECT to operate.

Chassis

Ground

Solenoid

Vehicle Starter

To Battery

SUPER AUTO EJECT

Truck Wall

Gasket 

Note: notch at

bottom

Weather

Proof Cover

#8-32 x 1-1/4”

Pan Head

Screw

Wiring Diagram SUPER AUTO EJECT

Incoming 

Power to Vehicle

Wh

ite

Bl

ac

k

Note: Place the gasket 
with the notch at the 
bottom when installing

Reviews: