current through the DC load shunt. Go to the sub-menu of the
DC AMPS calibration menu and adjust the value up or down
using the up or down buttons so it matches the measured
reading then press the
*
(accept) button when done.
F) Set-Up
Selecting the SETUP menu brings up the following sub-menu:
ACCESS CODE
ZERO GENERATOR HOURS
MAINTENANCE ALARM
CURRENT
p
VALUE
RESET ALARM BELL
f
BACKACCESS CODE
f
Lets the user change the access
code
ZERO GENERATOR HOURS
f
Will ZERO the generator
hours (after asking if sure)
MAINTENANCE ALARM
f
User can set the Maintenance
alarm value
CURRENT
p
VALUE
f
User can set the current value to
count down from (Hours)
RESET ALARM BELL
f
Remove RED alarm bell symbol
from Main Page (maintenance
alarm) and Resets “CURRENT
p
VALUE” to “MAINTENANCE ALARM”
value
f
BACK
A) Access Code Setting
If no key has been pressed for 60 seconds from any of the
menus or submenus, the instrument will revert to displaying the
Main Page.
The ACCESS CODE is required to access alarm settings,
instrument setup and calibration menus. Set the ACCESS
CODE to a number from 0000 to 9999 by using the
p
or
q
keys then press the
+
key to accept. The factory default is set
to 1234.
If the ACCESS CODE is ever forgotten, the instrument can be
reset back to factory default (see “Reset to Default”). Caution:
Resetting to factory default will reset all alarm and calibration
settings as well.
B) Zero Generator Hours Setting
Select this to set the TOTAL GENERATOR HOURS to zero
either for new generator installs or after a generator has
been replaced.
C) Maintenance Alarm Setting
This sets the alarm interval for the RED maintenance
indicator bell.
Setting the MAINTENANCE ALARM value to zero will disable
the maintenance alarm. The RED bell will not be displayed and
the current maintenance alarm value will be set to zero.
CURRENT
p
VALUE
This is the hours remaining before maintenance alarm. Note:
This value is set to “maintenance alarm” value when you do
reset alarm bell
D) Details Display
Selecting the DETAILS menu brings up an information page
that displays:
SERIAL NUMBER (YYMMDDnnn)
ACCESS CODE nnnn
INSTRUMENT ON HOURS
AC VOLTS HI AND LO ALARM VALUES
FREQUENCY HI AND LO ALARM VALUES
AMPS #1 AND #2 HI ALARM VALUE
DC VOLTS HI AND LOW ALARM VALUES
DC AMPS HI ALARM
GENERATOR HOURS
MAINTENANCE ALARM VALUE
HOURS TO GO TILL MAINTENANCE IS REQUIRED
E) About
Selecting the ABOUT menu brings up an information page that
displays
Software Version (S/W)
Hardware Version (H/W)
NEWMAR web page
170 Cherry Avenue
West Sayville, NY 11796
www.kussmaul.com
Ph: 800-346-0857
Fax: 631-567-5826
6
