SAFETY INFORMATION
The following safety information must be
observed to ensure maximum personal safety
during the operation of this meter.
1.
Do not use the meter if the meter or test leads
look damaged, or if you suspect that the
meter is not operating properly.
2.
This meter is not recommended for high
voltage industrial use, for example, not for
measurements of 440V AC or 600V AC
industrial power mains. The unit is
intended
for use with low energy circuits to 600V
AC/DC or high energy circuit to 250V AC or
DC.
3. Turn off power to the circuit under test before
cutting, unsoldering, or breaking the circuit.
Small amounts of current can be dangerous.
4.
Use caution when working above 60V DC or
30V AC rms. Such voltages pose a shock
hazard.
5.
When using the probes, keep your fingers
behind the finger guards on the probes.
6.
Measuring voltage which exceeds the limits of
the Clampmeter may damage the meter and
expose the operator to a shock hazard.
Always recognize the meter voltage limits as
stated on the front of the meter.
6
~
!
International Electrical Symbols
Dangerous Voltage
See Explanation in Manual
AC Alternating Current.
Double Insulation (Protection Class II)
DC (Direct Current).
Both DC & AC
Not to be exposed to dripping or splashing environment.
Warning :-
- +
~
Deficiency of Built in Battery.
Continuity Test
Diode
Fuse
Ground
Hazardous
live conductor
HAND Barrier
o
F
A
Hz
~
V
W
DATA
PEAK
!
CAT III 600V
A
Hz
~
V
WARNING :-
Typical meter applications are near
exposed lethal voltages. Use caution when taking
measurements. Before the meter is connected to
any circuit, review the safety information.
Always keep hands
behind the meter
HAND Barrier.
7