Kurzweil RE-220, Owner'S Manual, Page: 29 / 52

28 Display while playing and recording
Display while playing and recording
While recording and playing a song, the display shows the current measure of
the selected song and the Tap/Tempo button blinks at every beat. (At the first
beat, the green LED blinks) For example, if the time signature (described in the
Metronome section below) is set to 4, the displayed measure increases whenever
4 beats are counted.
Prepare for Recording
1. Select an empty Song by pressing either Song button (No track buttons are lit).
2. Before you begin to record, select the sound you want to record in the Sound
Select Section. Layered or Split Sounds also can be recorded on the same
track. Make any other desired settings (Reverb & Effects, Tempo, etc.) as well.
3. Press the Record button to enter Record-ready mode. The Record button and
the Track 1 button will blink, and track 1 is automatically selected. If you want to
record on track 2, just press the Track 2 button.
Start Recording
4. Just start playing any key on the keyboard; recording automatically starts (Key
Start). Or you can start recording by pressing the Play/Stop button or the left
pedal (Pedal Start).
5. When you finish playing a song on the track, press the Play/Stop button. Then,
recording stops.
6. OK. To listen to the recorded song, just press the Play/Stop button.
Additional Recording
7. If you want to record additional notes on track 2, press the Record button again
when the song is stopped. Then the Track 2 button will be automatically selected
and blink. If you press the Track 1 button, then you can re-record on track 1.
8. Repeat steps 4 - 5. You can record notes on track 2, while listening to the track 1
sounds.
9. Now, you can listen to both tracks by pressing the Play/Stop button.