Kurzweil KME-61 VERSION 2 SOFTWARE, Musician'S Manual

Page: 82 / 100

Chapter 9
Troubleshooting/FAQ
Switch Pedal Problems
If you are having problems with switch pedal, check these:
1. Be sure the pedal is plugged into the correct jack which has printed label “SW pedal”
above it. Be cautious. Plugging into the wrong jack might cause damage to your
instrument.
2. If Sostenuto is stuck, be sure the pedal is plugged in before switching on the power.
Turn power off then on if necessary.
3. If the pedal is acting backward ( active when up instead of down), turn power off then
on. Be sure the pedal is plugged in before turning power on and don’t use the pedal
until after the unit has completed its power up sequence.
Control Pedal Problems
If you are having problems making a control pedal work properly, check these:
1. Be sure the pedal is plugged into the correct jack which has printed label “CC pedal”
above it.
2. Do NOT use MONO Volume Pedal! This will cause system malfunctioning or damage
to your instrument.
3. If the pedal works backward, operates very abruptly, or not at all, it’s most likely a
wiring problem. See below for more information.
4. When using adapter cables to adapt a pedal with two mono cables, make sure that the
Y adapter is a stereo splitter type.
Kurzweil Service Centers
To locate the nearest Kurzweil Service Center for further assistance, please visit the following link.
http://www.kurzweilmusicsystems.com/
９-4