Kurzweil K2600 Series, Service Manual

Page: 15 / 172

Introduction
Rear Panel Features
1-3
Rear Panel Features
All Models
• Mix Outputs , use these two 1/4” jacks (Left is mono) to connect either T/S or T/R/S cables.
• Analog Outputs Bal/Unbal , con fi gure these 1/4” jacks (four pairs, A–D) as stereo pairs of
individual mono outputs.
• SCSI ports, use these two ports to connect a hard drive or other SCSI devices.
• SCSI Termination switch, a slide switch to select either Auto or Disable for SCSI
termination.
• MIDI ports, In, Thru/Out, and Out, to use with other MIDI devices to receive, pass, and
send MIDI data.
• MIDI Select switch, a slide switch to select the operation of the Thru/Out port.
• Kurzweil I/O , use these serial ports to send or receive the Kurzweil KDS format.
• Digital I/O , use these XLR jacks to send or receive digital information.
• Optical Out , use this jack to send or receive digital information from external devices with
an optical in jack.
Keyboard Models only
• Power Entry Module , includes the power switch, AC connector, fuse holder, and voltage
select switch.
• LCD Contrast , turn this potentiometer to adjust the LCD for the best visibility.
• CC Pedals/Breath , use these two 1/4” jacks to connect external control pedals (10k
Ω
linear
taper potentiometer, ring/tip/sleeve). Use the 3.5mm jack to connect a breath controller.
• Switch Pedals , use these four 1/4” jacks to connect footswitches.
• Inputs , this section is covered by a plate if the sampling option is not installed.
• For units with the sampling option, use either the two Lo Z XLR or the Hi Z 1/4”
(tip/ring/sleeve) jacks for sampling from an analog source.
• Optical In, If sampling from a digital source with an optical out jack, use this input.
• Headphones : use this 1/4” jack to connect headphones.
Rack Models only
• Power Entry Module , includes the AC connector, fuse holder, and voltage select switch.