© Kurth Electronic GmbH, All Rights Reserved
3
Turning On
press and hold
On/Off
button
for >1Second.
LOW BATT-LED
and
will flash shortly for
MODE-LED
two times if self-test was OK. If the battery voltage falls
below 7,5 V the red
LOW BATT-LED
flashes instead of
the green
MODE
-
LED
as On-Indicator. If the Battery
voltage falls below 5,1V the unit will turn off. This early
warning is important in case of being prepared to change
the battery in the right time to prevent unnecessarry
waste of time.
Function Mode
After the self-test the green
MODE-LED
shows for
10 seconds the selected trace tone. After this time the
LED flashes shortly every 3 seconds to save power.
Port 1 is always the remote control port to far end!
To see what trace tone or function is selected simply
press the
Mode
button
less than 1 second. Then the
green LED will show the selected mode. As default trace
tone 1 is on Port 1.
To change the mode press the
Mode button
longer than
1 second and release. Every press changes the mode.
For indication the
MODE-LED
flashes as follow:
Trace tone 1 on Port 1
Trace tone 2 on Port 1
Trace tone 3 on Port 1
Port 1 and Port 2 connected
After a correct command is received, the
MODE-LED
lights up for 1 Second.
How to use
www.kurthelectronic.de - sales @kurthelectronic.de
KE90x
REMOTE
PORT 2
PORT 1
PORT 4
PORT 3
Mode
On/Off
MODE
LOW BATT
Low
Batt
INFO
1
2
3
4
5
Connected
Connected
KE910
CONTROLLER
Trace ON
Shift
LS
Open
Port 1 + Port 4
Schleife
Port 1
Loop pulse 3 sec
Port 1
Port 1 + Port 2
Port 1 + Port 3
Second level
OFF
- Stop Trace
Change Trace Tone
KE910 Controller
KE905 Remote
Tone det control output
Speaker
Searchtoneoffbutton
LOW BATT LED
Sacknowledgement
LOW BATT LED
On/Offkey
Port 3
Port 4
Mode key
Port 2
Port 1
MODE LED
Control buttons
2x
Symmetrical
test cable