10
2
ENGLISH |
Table of Contents
Introduction .................................................................................................................3
Setup Instructions......................................................................................................4
Operating Instructions .........................................................................................5-7
DX6 Parts List ...............................................................................................................8
DX6 Mechanical Drawing........................................................................................9
Maintenance Schedule....................................................................................10-12
Troubleshooting Tips ............................................................................................. 13
Vise Data
Use this t
o fill out inf
ormation about your vise for quick reference.
Purchase Date:
_______ -_______- _______
Purchase Order:
_______________________
Purchased From: _______________________
Delivery Date:
_______________________
Serial No.:
_______________________
Note:
Make sure to register your warranty online at kurtworkholding.com
Table of Contents
CAUTION:
Is used when your action or lack of action may cause serious
injury.
OPERATING INSTRUCTIONS
PROPER CHIP GUARD INSTALLATION AND USAGE
Example: Part plus
3/4"
inch = Length of Chip Guard.
Note:
Remove Chip Guard stock
.
I
f left
uncut
,
the excess material
could
cause injury.
CAUTION:
Chip Guard stock shown above is provided to keep chips from
the nut and screw assembly and must be cut and deburred to
meet your application and safety needs.
SURFACE MOUNT USING SINE KEYS
Locating
the
3400/3410
can be done by the
use
our new
sine keys
as well
as
o
ur
standard keys. The
fixture keys
are available in several different sizes
that are listed on our website at www.kurtworkholding.com. The keys are
sold in sets of 2 per package.
English Mounting:
The
3400/3410
can be properly
located
using the
two
English sine key holes
indicated by the Y's in figure 5 above
or by using a standard 1/2 fixture key
in the key way
.
The 3400/3410 can be bolted down using the two 3/8" bolt
indicated in figure 5 above by OO.
The
3400/3410
vise can also be
mounted using
the four
9/16"
bolt slots on the sides of the vise
as well.
Metric Mounting:
The
3400/3410
can be properly
located
using the
two
Metric sine key holes
indicated by the X's in figure 5 above.
Fig.6
