Kurt CROSSOVER DX6H, Operating Instructions Manual

Page: 8 / 27

HYDRAULIC SET-UP
Jaw Positioning:
Once all plumbing is set up, it time to position jaws for hydraulic clamping .
1. Position jaws less than 1/4 inch from the part being clamped as is
s hown in figure 5 above. This is done manually by putting the handle
onto the hex end and turning the screw until the jaws are in position .
2. Make sure the jaws are less than 1/4 inch from the part since the
hydraulic unit has only a 1/4 inch stroke.
3. The vise is now ready to have the hydraulics engaged for clamping
the part.
Fig. 5
8
HYDRAULIC SET-UP