Instructions for use and installation instructions
36
Mounting the Appliance
•
Push the appliance for some 38 mm into the
kitchen unit and allow at least 4 mm free space
on both sides between the appliance and the
side walls of the kitchen unit (Fig. 1).
•
Widely open the door and put it together with
the kitchen unit door. The procedure is as
follows.
−
Fix the slide guides (attached in a plastic bag
along with the screws ST 4,2 x 9,5) to the
edge of the door. Cover the open holes with
the attached cap.
−
Put together the appliance door and the door
of the kitchen unit (Fig. 2).
−
Insert the slides into the guides and fix them
on the kitchen unit door some 15 mm from
the edge, using the A 4 x 12 screws (Fig. 3).
−
Remove the slide guides and separate the
appliance door from the door of the kitchen
unit.
−
Fix the slides and be careful not to move
them while fixing (Fig. 4).
−
Fix the slide guides to the original position.
−
Close the door and check the gasket (it
should not be creased). The door should
open and close smoothly.
NOTE:
Appliance with the height of 575 mm have only
one slide and one slide guide.
•
Fix the appliance into the kitchen unit. On the
upper side, fix the three screws A 4 x 12
through the rail and on the lower side with two
screws A 4 x 16, through the lower hinges. Drill
holes, ø 3 x 5 (Fig. 5).
•
Seal the gap on the opposite side of the hinge
with the enclosed seal (Fig. 6).
WARNING
Before mounting the appliance into the kitchen
unit, disconnect the power supply and set the
thermostat knob to STOP (0) position or switch
off the ON/OFF switch.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
