KCI 907.1E
17
I
Installation
Installation in a fitted kitchen
■
Be careful during fitting! Do not put or drop edged or pointed tools (screw-
driver etc.) on the glass top!
■
Any cooker hoods or wall cupboards must have a vertical clearance of at
least 650 mm from the hob unit.
■
The appliance must be installed absolutely horizontally.
■
The Küppersbusch built-in oven EEB 970 can be fitted underneath the profi-
cooking centre KC 906.2E.
The cooker is Y-type design, providing overheating protection for surrounding
surfaces (fitted cupboard components). The plastic coating or veneer must be
applied with a heat-resistant adhesive (100°C). This adhesive prevents the
surfaces from warping or working loose.
This appliance can be placed with its back wall and one side wall next to cup-
board or room walls of any height. The other side wall may only be placed
next to a fitted cupboard of the same height at the most.
– Have you connected the mains lead with the appliance?
– Using 4.2 x16mm screws, install the supporting rails in horizontal position
on the right and on the left onto the cupboard sides according to measure-
ments..
– Fit in the appliance.
– Fasten the appliance onto the supporting rails using 4.2 x 7 mm srews.
– Seal the appliance on the back and on the two sides with silicon.
The appliance sucks in air at the front (A) and emits air which has been heated
up at the rear (B).
Suitable measures must be taken to ensure that no warm air which has been
emitted in the area around B is sucked into the area of A once again. In order
to stop any unwanted circulation of air, the foam rubber mat (C), which is
enclosed, can be used, depending on installation conditions (Illustration 2)
For example: Attach the mat diagonally under the appliance with adhesive
strips so that the stream of air is stopped.
Important:
Stopping the flow of air must be carried out in accordance with the respective
installation conditions.
Please note
Should the appliance, on installation, have been sealed with silicone rubber on
three sides (on the worktop and the rear wall), this silicone sealing will have
to be cut open by customer service if necessary. Customer service will
subsequently seal the appliance with standard silicone rubber only.
