12
PGW 4000
Cleaning and care
[
Generally switch off the appliance before any cleaning operation is
performed and disconnect the power plug
[
Never dip the appliance into water!
[
Caution: When cleaning the grilling surface do not reach between grilling
surface and housing with the peak of the glass scraper!
■
Clean the grilling surface after every use.
■
Use only the glass scraper provided for removing large food particles left
from grilling.
■
Sugar and melted plastic
should be removed
from the hot grill surface
immediately using the glass scraper.
■
Never use abrasive materials such as steel wool or abrasive cleansers!
■
Never use cleansers which contain silicon. These will leave a film on the
grill surface which could be absorbed by the food upon next use. Therefore,
follow the instructions of the manufacturer in this regard.
■
We recommend you to rub down the grill surface with half a lemon or lemon
juice. Any slight dirt marks from protein, e.g. from meat, is removed and
the grill surface shines again.
Cleaning the grill surface
[
Make sure that no cleaning residuals remain on the grilling surface.
– First of all remove all food residuals and fat splashes from the hot grilling
surface by means of the glass scraper.
– Clean the grill surface with water and some detergent.
– Rewipe it with clear water and finally dry it.
F
In case there are still some soil particles left on the grilling surface after
cleaning, they can easily be removed by means of a special cleansing
agent, e.g. VSR O-FIX-C (available from the Küppersbusch Customer
service). Then wipe off the entire grilling surface with a wet and
afterwards with a dry cloth.
Cleaning the stainless steel parts
[
Stainless steel is very sensitive to scratches!
Do not use a cleaning scraper!
[
Remove any deposits of calcium or any spots of grease, and starch as
soon as possible, or stains will appear!
– Clean these parts with a soft sponge and a bit hand washing-up liquid.
– Then wipe them off with a dry cloth.
For the cleaning a cleaning agent for stainless steel can be used.
We recommend to clean once a week stainless steel surfaces with an usual
cleaning agent for stainless steel. This will create a protective film protecting
the stainless steel surface from discolouring.
What to do if trouble occurs...
[
Never unscrew the appliance! Repairs may only be carried out by an
authorized expert.
You can deal with some problems that occur yourself. First check whether
there has been any operating error. Repairs during the guarantee period are
not free of charge, when they are caused by operating errors or non-
observance of the following instructions:
Type plate
The type plate is located at the bottom side of the grilling surface.
When calling the Customer service or ordering spare parts indicate the data
given on the type plate.
– Take them down for possible consultations with our Customer service:
Fault
Cause
Remedy
Grilling surface cannot
be switched off.
Regulator is
defective.
Disconnect the mains
plug and hand over the
appliance to the
Customer service.
Grilling surface isn’t
heat
The grilling zone
regulator has not
been switched on.
Set the grilling zone
regulator.
Plug has not been
inserted?
Insert the mains plug.
Household fuse
defective?
Check and replace fuse.
Regulator or
grilling zone
defective.
Hand over the appliance
to the Customer service.
F-number:
Type designation: