Kuppersbusch MGV 6001, User Manual

Page: 12 / 24

4. Close the lid and press until it locks in
place.
Detergent tablets from different manu-
facturers dissolve at different rates. For
this reason, some detergent tablets do
not attain their full cleaning power during
short washing programmes. Therefore,
please use long washing programmes
when using detergent tablets, to ensure
the complete removal of detergent
residuals.
Use of combi detergent tablets
These products are detergents with a com-
bined cleaning, rinsing and salt functions.
They can also contain other different agents
depending on which kind of tablets you
choose ("3 in 1", "4 in 1", "5 in 1" etc...).
1. Check whether these detergents are
suitable for your water hardness. See the
manufacturers instructions.
The refilling of the salt container and the
rinse aid dispenser are no longer
necessary.
2. Select the lowest setting for water hard-
ness and rinse aid dosage.
If the drying results are not satisfactory
we recommend that you:
1. Fill up the rinse aid dispenser with rinse
aid.
2. Set the rinse aid dosage to position 2.
If you decide to turn back to the use of
standard detergent system we advise
that you:
1. Fill up the dispensers for salt and rinse aid
again.
2. Adjust the water hardness setting to the
highest setting and perform 1 normal
washing programme without loading any
dishes.
3. Adjust the water hardness setting ac-
cording to the hardness of the water in
your area.
4. Adjust the rinse aid dosage.
Select and start a washing programme
Select the washing programme with
the door slightly opened. The start of
the programme will occur only after
the closure of the door. Until then it
is possible to modify the settings.
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the On/Off button. The dishwasher
must be in setting mode.
4. Press the programme selection/cancel
button until the light corresponding to the
required washing programme comes on
(see "Washing programmes" chart).
Close the dishwasher door, the pro-
gramme starts automatically.
Warning! Interrupt or cancel a
washing programme in progress
ONLY if it's absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.
Cancel a washing programme in
progress
• Open the dishwasher door; press the pro-
gramme selection/cancel button for about
3 seconds, until the light of the running
programme goes off and the
End indicator
light flashes. The washing programme has
been cancelled and the appliance is now
in setting mode. .
• If a new washing programme is to be se-
lected, check that there is detergent in the
detergent dispenser.
12