1
2
Speed
Absaugleistung
First
Erste
Second
Zweite
Third
Dritte
Light
Beleuchtung
On
Ein
Off
Aus
3
Instructions for use
---------------------------------------------------
By pressing the button shown in the figure 2,
you will be able to control the functions of the
extractor
To achieve better extraction, we recommend
switching on the extractor a few minutes
before starting to cook (3 - 5 minutes) so that
the air flow is continuous and stable when
extracting the fumes.
Likewise, keep the extractor switched on for a
few minutes when cooking is complete to
allow all fumes and odours to be expelled.
Cleaning and maintenance
---------------------------------------------------
Before
carrying
out
any
cleaning
or
maintenance activities, ensure that the
extractor is disconnected from the mains.
To carry out cleaning and maintenance, follow
the Safety Instructions.
There is a fire risk if cleaning is not carried out
in accordance with the instructions.
Filter cleaning
To withdraw the filters from their locations
release the anchoring points. Clean the filter,
either by putting it in the dishwasher (see
notes) or leaving it standing in hot water to
simplify the removal of grease or, if wished, by
means of special sprays (protecting the non
metallic parts). Once clean, leave it to dry.
Notes:
cleaning in the dishwasher with
aggressive detergents may blacken the
surface of metallic parts, without this affecting
its gas retaining properties.
N.B.
The filter must be cleaned at least once a
month depending on how often the extractor is
used. It must be remembered that grease is
deposited in the extractor when cooking,
whether it is switched on or not.
Cleaning of the extractor body
The use of warm (40
º
C approx.) soapy water
is recommended. A cloth moistened in this
water is used for cleaning the extractor, paying
special attention to the grids. Afterwards, dry it
using a lint-free cloth.
Note:
* Never use metallic scouring pads or abrasive
products that could damage the surface.
* Do not use scrapers with metallic surfaces
such as knives, scissors etc.
Activated charcoal filter
* To install the charcoal filter, the motor
anchorage is made to coincide with the
anchor points of the activated charcoal filter
and turn it clockwise.
* The carbon filter lasts from three to six
months
depending
on
the
particular
conditions of use.
* The activated carbon filter can neither be
washed nor regenerated. Once it is
exhausted, it must be changed.
* To replace exhausted filters with new ones,
withdraw the old one in the reverse order to
that of installation.
Changing Bulbs
* Remove the filter support to acces the bulbs.
* Take
care
to
disconnect
the
mains
beforehand and that the bulbs to be replaced
are not hot.
* The maximum bulbs power is 40W.
Tecnical Information
(Fig. 3)
---------------------------------------------------
Dimensions
Width = 550 mm
Depth = 310 mm
Height = 175 mm
Dimensions for fitting
Width = 505 mm
Depth = 292 mm
Electrical characteristics:
REFER TO RATING PLATE
