22
EWE 457.1 / EWEF 457.1
Procedure
1. Glue the sealing tape
onto the corner of the supporting edge of the
worktop so that no Pactan
can be pressed under the hob.
[
Only use the sealing tape that is supplied with the hob!
Should you use any other sealing there is no guarantee that the hob will
not sink down after installation.
2. Insert the hob without adhesive into the worktop opening and check the
height. If necessary, place the shims provided on the support edge for the
hob at equal distances to adjust the height.
3. Remove the hob again.
4. Use the water-proof primer to pre-treat the outer edges of the hob and the
side cut surfaces of the worktop where they have been glued.
Apply a thick coat of the primer with a brush on highly absorbent surfaces
(e.g. chipboard).
With less absorbent surfaces (e.g. marble or granite) it is sufficient to apply
the primer with a felt cloth.
Important!
After application, the primer must be left for about 30 minutes.
5. Now insert the hob and align.
6. Finally, fill the gap between the hob and the worktop with Pactan
.
7. Smooth the joint with a spatula and water containing a little washing-up
liquid.
[
Attention!
Use sealing tape! Pactan must not get under the support
surface. If this occurs it will not be possible to remove the hob again at
a later stage. No liability will be assumed in the case of failure to observe
these instructions.
Electrical connection
■
Statutory regulations and the connection specifications issued by the local
power supply company must be strictly observed.
■
Ensure that all live connections are safely insulated when installing the oven.
■
The appliance is supplied ready to plug in. It should be connected only to
a properly protected wall socket. Installing and wiring a socket or replacing
the connection cable should only be performed by an electrician and in
observance of the relevant regulations.
■
If the socket is inaccessible after the installation, safety regulations require
that an all-pole isolator with a contact opening of at least 3 mm be used
on the installation side.
■
The wall-socket can be mounted under the working top below the hob or
in a side cupboard in the wall. Do not mount it above the cooking area!
Connection
standard mains plug into a wall socket.
Power consumption
at 230 V: 2.5 kW,
Electrical connection
230 V, 50 Hz
Fuse current
16 A
