EEB 9550.0
27
The electronic timer
As well as providing a short-time alarm for reminders, the electronic timer con-
trols the oven in several other ways. You can use it to set the cooking time
and the finish time. All functions are available in any mode or temperature
selection.
Display:
Time, alarm time (actual value in each
case)
Lamps, showing that the oven is
switched on.
Lamps (for each selector button/function)
Selector buttons:
7
Cooking time
8
Finish time
4
Alarm time
Adjust:
+/- for altering the values of all functions.
Setting/changing the clock
– Push simultaneously “
7
” and
“
8
”, until the time in the display
flashes.
– Adjust as required using “+”/“
-
”.
– Wait for the display to stop flashing. The
time will then be accepted, and the dot
in the centre of the hour and the minu-
tes will flash every second.
Setting the alarm time
You can use the alarm on its own, without effecting the oven.
– Press “
4
”. The lamp will flash. The dis-
play will read “0.00”.
– Use “+”/“
-
” to set the timer in minutes
and seconds.
– Start the timer with “
4
” or wait until the
lamp stops flashing. You will see in the
display the time remaining until the buz-
zer sounds.
An acoustic signal is generated when the
alarm time has elapsed.
– Press any button to stop the buzzer. The display will show the normal clock
again.
This is how to programme the switching operations
1. Selecting the operation:
– Press the selector button for the operation you wish to use. The lamp above
the button you have pressed will start to flash and a number will appear in
the display.
2. Altering/adjusting the operation:
– Adjust the value shown, using “+” and “-”.
3. Starting the operation:
If you do not press another button for 3 seconds, the operation will commence
automatically and the lamp will stay on all the time.
F
You can reduce the time by pressing a selector button:
- the previously selected button confirms the input and starts the operation.
- another button confirms the input and selects the new operation you have
chosen.
4. Setting the oven functions (switching functions only):
– Use the mode selector to select the mode and the temperature control to
select the temperature.
If you wish, you can set the temperature and mode before programming the
timer.
Changing the setting
If you wish to alter a setting you have made – even if the operation is running
– push the appropriate button again and use “
+
”/“
-
” to change the value in
the display.
When the cooking time is finished
the oven will switch off and “End” will ap-
pear in the display. A warning signal will
sound. Both of the lamps next to the dis-
play will stop flashing.
– Press any selector button to stop the alarm buzzer.
The display will show the normal clock again. The oven starts again.
– Turn the temperature control and the mode selector switch to “0”.