Service Manual EDG 650.0
19
For internal use only
6.14
Removing the door
1.
Open the door to its fullest extent.
2.
Insert pins (A) into the holes in the hinges.
3.
Push down both round buttons (B) on the door in front
of the hinges. Press down on the hinges.
4.
Pull out the door on its sliding rails.
6.15
Removing the hinges
1.
Pull out the upper bottom and side panels.
2.
With the door closed, pull back the springs.
3.
Remove the fixing screws on each hinge and lift off the hinges.
6.16
Renewing the interior light
1.
The lamp is located behind a cover at the rear of the interior on the right.
Unscrew the lamp cover and its seal from the holder.
2.
If necessary, clean the cover and seal with warm water and soft soap.
3.
Unscrew the bulb from its holder and replace with a new one of the same type
(25 W, 220/240 V).
Heat resistant up to 300 °C
Bulb holder: E 14
4.
When you screw back the lamp cover, make sure that you fit the seal as well.