18
Technical passporT
english
dishwasher
Â
The socket is compatible with the plug
of the appliance.
If this is not the case, ask an authorised
technician to replace the plug (see AFTER-
SALES SERVICE). Do not use extension cables
or multiple sockets. Once the appliance has
been installed, the power supply cable and the
electrical socket should be easily accessible.
The cable should not be bent or compressed.
If the power supply cable is damaged,
have it replaced by the manufacturer or its
authorised Technical Assistance Service in
order to prevent all potential hazards.
The Company shall not be held responsible
for any incidents, if these regulations are not
observed.
POSITIONING AND LEVELLING
1. Position the dishwasher on a level
sturdy fl oor. If the fl oor is uneven, the front
feet of the appliance may be adjusted until it
reaches a horizontal position. If the appliance
is levelled correctly, it will be more stable and
much less likely to move or cause vibrations
and noise while it is operating.
2. Before recessing the dishwasher, stick
the adhesive transparent strip under the
wooden shelf in order to protect it from any
condensation which may form.
3. Place the dishwasher so that its sides or
back panel are in contact with the adjacent
cabinets or the wall. This appliance can also
be recessed under a single worktop.
4.
To adjust the height of the rear foot,
turn the red hexagonal bushing on the lower
central part at the front of the dishwasher
using a hexagonal spanner with an opening
of 8 mm. Turn the spanner in a clockwise
direction to increase the height and in an
anticlockwise direction to decrease it.
AFTER-SALES SERVICE
CONTACTING AFTER-SALES SERVICE
When you contact the After-Sales Service,
you must provide the codes shown on the
rating plate attached to the left or right side
inside the door of the dishwasher.
The phone number is listed in the warranty
booklet or on the Kuppersberg website:
h
ttp://www.kuppersberg.ru.
TECHNICAL DATASHEET
The technical data containing the energy
consumption data can be downloaded from
the Kuppersberg website:
http://www.kuppersberg.ru.
DIMENSIONS, CAPACITY AND
STANDBY CONSUMPTION:
WIDTH
595
mm
HEIGHT
820
mm
DEPTH
580
mm
CAPACITY
14
standard place-settings
STANDBY CONSUMPTION: Left-on mode -
5 W
Off mode -
0,5 W
