Kuppersberg ESO 602, Manual

Page: 29 / 60

29
ENGLISH TECHNICAL PASSPORT
Ceramic hobs
touch button you must lower the con-
tinuous cooking power to the desired
level (for example 6). When the auto-
matic cook function is activated, the
«A» indication flashes and the desired
power level is shown on the display.
SWITCHING THE AUTOMATIC COOK
START FUNCTION OFF
After at least 10 seconds have elapsed
since the beginning of the automatic
cook start function:
1. The hotplate must be selected.
2. Press touch button (5) till the indi-
cator reaches level 9 and the automatic
cook start function will be deactivated.
TIMER FUNCTION
This function makes cooking easier,
as you do not need to be present dur-
ing the whole process: the hotplate(s)
with the timer on will switch off auto-
matically after the set time has elapsed.
There is a separate timer for each hot-
plate, which allows all of the hotplates
to be timed simultaneously.
In these models you can use the clock
as a timer for the hotplates, setting the
time between 1 and 99 minutes. All
cooking zones can be programmed in-
dividually and in a simultaneous man-
ner.
TIMING ONE HOTPLATE
1. The cooking zone to set the time
must be selected.
2. Select a power level for the hotplate
(from 1 to 9) using the touch button
or (5/4).
3. Press the clock touch button (10).
Timer indicator (11) will display 00. The
indicator (12) of the hob with timer will
flash (depending on the model).
When setting the time, the symbol
flashes on the power indicator (3).
4. Immediately afterwards, enter a cook-
ing time between 1 and 99 minutes, by
using the touch button or (5/4).
When the power indicator (3) stops
flashing, it will start to count down
the time automatically. The respec-
tive timed hotplate display (11) will
continue flashing. Or, when the count -
down starts, the corresponding power
level and the symbol will flash al -
ternately on the power indicator (3) of
the respective heating zone. When the
clock reaches 01, it will switch counting
down from minutes to seconds.
Once the selected cooking time has
elapsed, the heating zone being timed is
turned off and the clock emits a series of
beeps for several seconds. The timer indi-
cator will display a flashing “00” next to
the hotplate that has been disconnected.
If you wish to time another hotplate at
the same time, repeat steps 3 and 4.
If the heating zone turned off is hot, its
indicator displays an H or otherwise an
0. To turn off the audible signal touch
any sensor.
CHANGING THE PROGRAMMED TIME
To change the programmed time, you
must press the touch button of the pro-
grammed hotplate (2) to select it and
then press the clock button (10). You
may then read and change the time.