Bona Belt Manual
9
EN
9
Commencing Operation (Cont.)
Dismantling the machine
1) The machine can be taken apart into four parts for
transport.
2) Put down the belt protector.
3) Reduce the tension on the driving belt by loosening the
eccentric tightener.
4) Roll off the driving belts.
5) Hold onto the motor handle and lift up the motor from the
rear motor bracket.
6) Push the control lever forward and down
.
7) Pull up the sliding sleeve.
8) Loosen the locking wheel and pull up the handle shaft.
9) Lift up the dust bag together with the dust pipe upward until
it loosens from the pipe holder.
10) Carry the machine frame by holding the handle and the tilt
support.
Instructions for electrical connections
This machine only operates
with the voltage and
frequency shown on the
machine data plate. Before
connecting the cable to
the power supply ensure
the correct voltage and
frequency are available.
DO NOT expose the machine to rain. This machine is
intended for dry use only. Keep the machine in a dry building
and DO NOT use it in damp or wet places.
If the machine is not connected correctly to the electricity
network, death due to electrocution may occur. To prevent
electric shocks always use a grounded three wire electrical
system. For maximum protection against electric shocks use
a circuit protected with a differential cut-out switch.
Tampering with the grounding plug in any way may result
in death from electrocution. DO NOT cut, remove or break
the grounding plug. If the socket does not match the plug
consult a qualified electrician.
If the machine is used with a
damaged plug or power sup-
ply cable, death may occur
from electrocution. If cables or
plugs are worn or damaged in
any way, have them replaced
by the manufacturer or
certified machine repair center
in order to prevent risks to
safety.