Bona Belt Manual
13
EN
13
Starting the Machine
To start the machine proceed as follows:
1) Become familiar with the machine and read all instructions &
safety notices. Ensure that all operators read this manual.
2) Start/Stop occurs via the I/O switch. Operating mode is
obtained directly after start. If the motor, e.g. if cold, or
when the machine is new, should be difficult to start button
can be held in until the motor has come up into its normal
operating mode.
The motor is equipped with no volt release and overload
protection If the protection has triggered, the motor can start
normally after several minutes.
Always use original cableage, 1-phase 3x2.5 mm²
(ASO904014).
NOTE! Never lower the sanding drum before
the motor is up in the correct running mode.
Machine Adjustment Procedures
Regulation Drum pressure
1)
Using the control wheel, the drum pressure can be regulated at high,
medium and low in accordance with the following:
Highest position = low drum pressure
~23 kg
Medium position = medium drum pressure
~27 kg
Lowest position = high drum pressure
~32 kg
Changing the sanding belt
A sanding belt is mounted upon delivery. When changing to
another belt, do the following:
Remove the power
cable from the motor.
1.
Unlocking the side cover
and open it.
2.
Push in the tool until it
reaches the bottom of the
hole on the belt tensioner
arm.
3.
4.
Press the tool directly down
until the mechanism locks in
the bottom position.
