| 19
en
TIG DC LIFT
- Setting the DOWN SLOPE function
(curren decrease)
the function is used for the continuous termination of the welding process.
together with the eNd curre Nt function, it prevents crater formation at
the end of the weld when properly adjusted. during the set time, the wel
-
ding current drops to the value of the end current.
the function is activated
by pressing the FuNctioN button (Fn), the function is selected by rotating the
control n-coder i in sequence, the function parameter is set by pressing the
control n-coder ii.
MIG
VOLTAGE
WIRE SPEED
CURRENT
AIR
TEST
WIRE
FEED
FuNctioN button
tiG liFt
n-coder ii
n-coder i
TIG DC LIFT
- Setting the POST-GAS function
this function ensures the protection of the weld after the welding process.
the function is activated by pressing the FuNctioN button (Fn), the func
-
tion is selected by rotating the control n-coder i in sequence, the function
parameter is set by pressing the control n-coder ii .
MIG
VOLTAGE
WIRE SPEED
CURRENT
AIR
TEST
WIRE
FEED
FuNctioN button
tiG liFt
n-coder ii
n-coder i
TIG DC LIFT
- Setting the 2-STROKE function
the function indicates how the welding process is activated. When using
this mode, it is necessary to press the torch button during welding, which
sends a signal to activate the welding process. pressing the torch button
starts the welding process and activates the sequence of functions. to acti
-
vate the function, press the control button one after the other.
MIG
VOLTAGE
WIRE SPEED
CURRENT
AIR
TEST
WIRE
FEED
control button
2t
tiG liFt
TIG DC LIFT
- Setting the 4-STROKE function
the function indicates how the welding process is activated. When using
this mode, it is necessary to press the torch button, which sends a signal to
activate the welding process. the pre Gas function is then activated, follo
-
wed by start curreNt. When the button is released, the welding process
starts by switching to WeldiNG curreNt and activating other active func
-
tions gradually. to complete the welding process, press the torch button
again to activate the doWN slope function and then the eNd curreNt
function. When the button is released, the welding process is terminated
and the post Gas function is activated.
MIG
VOLTAGE
WIRE SPEED
CURRENT
AIR
TEST
WIRE
FEED
control button
4t
tiG liFt
Methode MIG/MAG
machine is equiped with manual control mode. the user must set the wel
-
ding parameters manually. this is a standard process, depending on the set
parameters in a short / liquid arc.
MIG/MAG
- Setting the welding process
Welding current is set by n-coder i. speed of wire feeding is set by n-coder ii.
MIG
VOLTAGE
WIRE SPEED
CURRENT
AIR
TEST
WIRE
FEED
miG/maG
n-coder ii
n-coder i
