KUHN GA 8001 H, Assembly And Operators Manual

Page: 20 / 52

- 18 -
7. Adjusting the transport wheels (fig. 6)
The transport wheel alignment is pre-set in the factory. However, this setting can be checked using 2 straight
boards (4) placed against the sides of the transport wheels.
Position hole (6) punched in lever (7) under hole (8) of the rear wheel column support (9). The boards (4) should
be parallel to the frame tube. If not, proceed as follows :
- Adjust yoke (11) on the drag link (12) of the wheel(s) concerned until the correct parallelism is obtained. Make
sure hole (6) remains positioned under hole (8).
- Retighten the counter-nuts on yoke (11).
- Remove the pin which connects toggle joint (5) to lever (7).
- Place the swivel hitch (3) perpendicular to the frame tube using a set square (1). Position the rear side of swivel
hitch (3) parallel to the second side of the set square.
- Adjust the toggle joint (5) of the rear track rod so that the mounting pin holes line up.
- Install pin and secure it in place.
- Tighten counter-nut (10).