KUHN AXIS 20.1, Operator'S Manual

Page: 59 / 216

Standard operating procedure (all models)
47
8
AXIS-GENERAL
8.5.2 Maximum approved hopper mounting height at front (V) and rear (H)
The maximum approved hopper height (V + H) is measured from the ground
to the bottom edge of the frame.
Figure 8.8: Maximum approved hopper mounting height V and H during nor-
mal and late fertilisation
The maximum approved hopper height depends on the following factors:

Normal or late fertilisation.
Spreader equipment Maximum approved hopper mounting height
during normal fertilisation during late fertilisation
V [mm] H [mm] V [mm] H [mm]
AXIS 20.1
AXIS 30.1/AXIS 40.1
1040 1040 950 1010
AXIS 50.1 W 990 990 900 960
V H