Kuhling&Kuhling RepRap Industrial, Operating Manual

Page: 6 / 24

Now you have access to the Expert Controls and
some of the Setup functions to adjust whatever
might be necessary.
To continue printing tap [Resume Print]
(replaced [Pause Print]). Print bed and extruder
head move to their last position and after re-
heating the extruders the print seamlessly
continues.
Continuing the print after pause.
Finishing a print job
There are two ways to finish a print job:
automatic finish after completion or abortion by
the operator.
After regularly completing a print job all axes are
moved to their home position and the extruder
heating resistors are switched off.
If you need to abort a print job because the
outcome does not meet expectations for
example or mechanical problems appear during
the print, tap the [Abort Print] button. The
system will then print the last G-code
information from cash and move the print table
and the extruder head to their home positions
afterwards.
Either way, the 3D printer returns to idle mode
and displays a status message and a request
how you wish to continue. Simply tap the
respective button on the screen to proceed.
After standstill of all drives you can remove the
print bed and take off the model.
No. Description Content/Function
9
[Keep in
Queue]
Returns to the Print menu.
10 [Print Again]
Immediately restarts the
current print job.
11
[Delete
Printjob]
Deletes the finished print
job from the queue
without confirmation and
returns to the
Print menu.
Print job finished.
Switching off the 3D printer
NOTICE
Switch off the 3D printer via the power button without turning it into standby may cause damage of
the heating elements and neighboring components due to residual heat.