8
4.4.
Unpacking
Note: Before unpacking check the damage is whether due to the transportation or not, if you
find any such damage, please do not use this item, and contact with the dealer or
manufacturer as soon as possible.
•
Open the fly-case, and discover the inside plastic bag.
•
High-lift the product by two handles beside the bottom base and move it out.
•
Before power on, make sure you have opened the X, Y axis lock!
5.
Install standard
5.1.
Install lock
HOT BEAM 2R can be placed on the stage, or mounted in an arbitrary direction of the truss. Two
fast locks system could fix the item easily.
5.2.
Equipment fixed
•
Before installation must verify the fast lock is keep in good state, and can withstand at
least 10 times the weight of product. Verify that the building can withstand at least 10
times of the total weight of the product and accessory
equipment’s
.
•
Fix the hang fixture into the hole, which located on the base of the price.
•
Seize handle of fasteners, clockwise rotate 1/4 turn and lock. Installed other one
fastener
•
in the same method.
•
Using the safety cable which can withstand 10 times the weight of the equipment.
•
Make sure the X, Y protect locks are opened, verify that within 3 meters there is no
combustibles.
WARNING
Fixture must use two fixing devices, and make sure the fixing device have locked! And only
fully clockwise rotate 90 ° can lock the hang fixture! Do remember plus a safety rope, and do
not connect the safety rope to plastic handle. It should be connected to the hole on the base!
5.3.
Fixture connects
Attention! One product only can accept one input one output.
HOT BEAM 2R
DMX cable include 3 contact pins:
Pin 1, FOR GROUND;
Pin 2 connected to the negative polarity signal; The pin 3
connected to the positive polarity signal.
DMX512 cable must use the professional shielded twisted pair cable; standard
loudspeaker cable is not reliable to control the long-range data. 24AWG cable is
suitable for more than 300 meters long-distance signal transmission and must add\
DMX 512 signal amplifier.
Do not use two outputs to separate the connection, if separate a continuous
connection to branch, DMX512 splitter is necessary.
If use the DMX512 splitter. At first connect DMX512 Splitter input terminal to
