KFR11AC-128R-16F
5
WAN:
10/100Mbps RJ45 port. The WAN port is where you will connect Cable/xDSL
Modem or other LAN.
LAN (1,2,3,4):
These four LAN ports are where you will connect networked devices, such
as PCs, print servers, remote hard drives, and anything else you want to put on your
network. If you connect this product with the Hub (or Switchboard) correctly, the Router’s
corresponding LED and the Hub’s (or the Switchboard’s) must be illuminates.
WPS:
With the Router powered on, press the button about 1 second, it is WPS function
and the WPS LED will flash two minutes.
RESET:
With the Router powered on, use a pin to press and hold the button about 7
seconds, the Router will reset to default setting.
ON/OFF:
The switch for the power.
POWER:
The Power socket is where you will connect the power adapter. Please use the
power adapter provided with this Router.
Wireless antenna:
To receive and transmit the wireless data.
2.3 Typical install
Before installing the Router, make sure your PC is connected to the Internet through the
broadband service successfully. If there is any problem, please contact your ISP. After
that, please install the Router according to the following steps. Don’t forget to pull out the
power plug and keep your hands dry.
1. Make sure all devices, including your PCs, modem, and Router, are powered down.
2. Using an Ethernet network cable, connect the LAN or Ethernet network port of the
cable or DSL modem to the Router’s WAN port.
3. Power on the cable or DSL modem, and power on the PC you wish to use to configure
the Router.
