28
Operation
Engine shut-off cord (lanyard)
Inspect the engine shut-off cord and clip for
damage, such as cuts, breaks, and wear.
1.
Clip
2.
Cord
Engine oil
1.
Place the outboard motor in an upright
position (not tilted).
NOTICE:
If the motor is
not level, the oil level indicated on the
dipstick may not be accurate.
2.
Remove the oil filler cap and wipe the
attached oil dipstick clean.
1.
Oil filler cap
2.
Oil lubrication check window
TIP:
The oil lubrication check window does not
indicate the engine oil level. Use the oil lubrication
check window to make sure that the engine is
being lubricated with oil while it is running.
3.
Install the oil filler cap and tighten it
completely.
4.
Remove the oil filler cap again and check that
the oil level on the dipstick is between the upper
and lower marks. If the oil level is not at the proper
level, add or extract oil until the oil is between the
upper and lower marks
.
1
2
3
1. Oil dipstick
2. Upper mark
3. Lower mark
Install the oil filler cap and tighten it completely.
1
2
1
Summary of Contents for MOTOR99
